Fate of azadirachtin A and related azadirachtoids on tomatoes after greenhouse treatment

The degradation of the main azadirachtoids on tomatoes was studied after greenhouse treatment. These experiments were carried out at 1 and 5× the concentration recommended by the manufacturer. In all experiments the deposition of azadirachtin A (AZA-A) was below the maximum residue level (MRL). Even if at the highest dose, AZA-A half-life time calculated as pseudo first order kinetic was 1.2 days in agreement with the recommended preharvest interval (PHI) of 3 days. Experiments with a model system showed that sunlight photodegradation is the main factor influencing the rate of disappearance of AZA-A after greenhouse treatment while tomato epicuticular waxes doubled the photodegradation rate of AZA-A in a commercial formulation.     

Knowledge spillovers and subsequent innovation in green energy: the role of public R&D

Environmental Science and Pollution Research -     

Effect of straw retention on carbon footprint under different cropping sequences in Northeast China

Environmental Science and Pollution Research - Inappropriate farm management practices can lead to increased agricultural inputs and changes in atmospheric greenhouse gas (GHG) emissions, impacting...     

巴丹吉林沙漠与库布齐沙漠植被现状调查

本文通过对巴丹吉林和库布齐两大沙漠的共计12个点位的植被调查显示,两大沙漠植被均以灌木建群,都伴生大量一年生沙生先锋植物;库布齐沙漠植物群落中,多年生草本物种数增加,是群落趋于稳定的表现;库布齐沙漠人工治理力度较大,使得群落生境趋优速度加快。巴丹吉林沙漠植物群落基本处于自然状态。     

北方冬季农村供暖对PM2.5的影响及解决方案研究

为研究北方冬季农村供暖对PM2.5的影响,我们在北方的部分乡镇农村进行了为期一年半的调查走访,结果表明,北方冬季农村供暖用煤总量大,利用效率低,其生活用煤产生的烟尘总量相当于工业用煤的2.7倍,加之村落人口密集,室内通风条件差,故现有的供暖形式对人体健康危害很大。针对供暖方式的研究,我们提出了在农村推行集中供暖的方案。     

Review of the progress in preparing nano Ti02： An important environmental engineering material

TiO2 nanomaterial is promising with its high potential and outstanding performance in photocatalytic environmental applications, such as CO2 conversion, water treatment, and air quality control. For many of these applications, the particle size, crystal structure and phase, porosity, and surface area influence the activity of TiO2 dramatically. TiO2 nanomaterials with special structures and morphologies, such as nanospheres, nanowires, nanotubes, nanorods, and nanoflowers are thus synthesized due to their desired characteristics. With an emphasis on the different morphologies of TiO2 and the influence factors in the synthesis, this review summarizes fourteen TiO2 preparation methods, such as the sol-gel method, solvothermal method, and reverse micelle method. The TiO2 formation mechanisms, the advantages and disadvantages of the preparation methods, and the photocatalytic environmental application examples are proposed as well.     

黑河下游额济纳河流域生态环境现状及发展趋势

本文通过资料和监测数据阐述了2006—2011年黑河下游额济纳河流域生态环境现状及其变化趋势。土地覆盖监测数据结果表明,截至2011年额济纳河流域绿洲面积达3232km^2,水域湿地面积达118km^2,额济纳绿洲植被覆盖度总体呈增加趋势,局部地区增加显著,而个别地区植被呈缓慢退化。水资源调查数据说明。额济纳河流域绿洲的维持和恢复仍取决于黑河水的补给量,近几年黑河水在额济纳境内的进入量基本能维持额济纳现有绿洲规模。     

清水江流域环境保护污染治理经济效益分析

以《贵州省清水江流域环境保护规划(2013-2020年)》为例,分析清水江流域治理主要污染物的削减量和费用支出。从环境经济角度,通过费用-效益分析法以货币量化进行计算,流域治理能带来一定的经济效益、环境效益和社会效益。     

清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。     

An isolated AC module for photovoltaic energy conversion

In this paper, an isolated ac module with pseudo dc-link and galvanic isolation is proposed for photovoltaic energy conversion. The studied grid-tie ac module can individually extract the maximum solar power from each photovoltaic panel and transfer to ac utility system. It consists of an interleaved active-clamping single-ended primary-inductive circuit (SEPIC) with a secondary voltage doubler, a full-bridge polarity selector operating under line frequency to achieve high efficiency. For the studied topology, key features such as reduced input current ripple, zero-voltage switching (ZVS) of primary switches, low reverse-recovery current of the output diodes, and lower switch voltage stress are obtained. Also, to reduce input current ripple, an interleaved control strategy is adopted. A simple control strategy is proposed to generate a rectified sinusoidal waveform voltage at the pseudo dc-link capacitors and achieve the high maximum power point tracking (MPPT) accuracy. The operation principles and design considerations of the studied ac module are analyzed and discussed. A prototype with 25–60 V dc input, 110 V/60 Hz ac output and 150 W power rating has been constructed for verifying the feasibility of the proposed ac module.